Checking The Enclosed Parts; Assembling The Stand - Pioneer PDK-1011 Mode D'emploi

Checking the Enclosed Parts

Check to make sure that you have all the enclosed parts
before assembly and installation.
Table top stand x 1
Support columns x 2
Installation screws 1 (M8 x 20 mm [13/16 inch]: silver) x 2
[used to anchor the support columns and the table top stand]
Installation screws 2
(M8 x 30 mm [1-3/16 inch]:
black) x 2
Hexagonal wrench x 1
(Diagonal size: 5 mm [3/16 inch])
Installation screws 3
(M8 x 40 mm [1-9/16 inch]:
black) x 2
Operating instructions
(this document) x 1
Table top stand
Support de couverture de table
PDK-1011
Operating instructions
Mode d'emploi

Assembling the Stand

Note
Always assemble it on a flat table etc.
Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
Assembly Procedure
1
Attaching the support columns to the stand.
Insert the head of the screw in the support column into
the hole for the support column in the stand and then
slide it downward.
Front side
2
Attach the support column to the stand
with the attachment screws 1 on the left
and right of the stand.
Use the enclosed hexagonal wrench to vertically tighten
it in the top hole from the rear.
3
Fully tighten two screws on left and right
of stand which have been loosely screwed
into stand.
Use the provided hexagonal wrench to fully tighten the
attachment screws which have been loosely screwed in
on the left and right sides of the stand.
4
Reconfirm that the attached screw is
firmly tightened.
Support column
attachment hole
Attachment screw 1
Tighten the two screws
which have already
been screwed into the
stand.
3
En