Checking The Standard Accessories; Assembling The Stand - Pioneer PDK-TS30 Mode D'emploi

Checking the Standard Accessories

Check to make sure that you have all the standard accessories before assembly and installation.
Base cover × 1
Light-blocking shield × 1
(PDK-TS30A only)
1
Screw
(M5 × 10 mm: black) × 6

Assembling the Stand

Assembly Procedure
1
Turn the base cover over so the underside
is facing up.
2
Insert the stand pipes into the base cover.
Insert stand pipe (R) into the side marked "R" and stand
pipe (L) into the side marked "L".
3
Tighten the screws
to stabilize the stand pipes.
Note
Assemble the stand with a soft sheet placed under the base
cover. If a sheet is not laid before assembly, the front surface
of the base cover may be scratched.
Please take care when installing stand pipes (L) and (R) to
ensure that they are in the correct positions. Mistakenly
installing the stand pipes may damage the stand.
Fall-prevention strap × 4
Installation screw
(M6 × 20 mm: black) × 4
(M5 × 10 mm: black)
1
Stand pipe (L) × 1
2
1
Screws
(M5 x 10 mm: black)
Stand
pipe (R)
Front
Completed
Table Top Stand
Sheet
Stand pipe (R) × 1
Operating instructions
(this document) × 1
3
Screw
(M4 × 10 mm: black) × 4
1
Screws
(M5 x 10 mm: black)
Rear
Stand
pipe (L)
Base cover
9
En