Attaching The Plasma Display - Pioneer PDK-1011 Mode D'emploi

Attaching the Plasma Display

The weight of a 50 inch plasma display is about 40 kg
(88 lbs), that of a 43 inch model is about 30 kg (66 lbs),
they have no depth, and are unstable. Therefore, at
Caution
least two people must assemble and install them.
Note
Be sure to install it on a flat stable location.
Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
Attachment Method
1
Attaching the plasma display to the stand.
Fit the stand's support columns into the slots in the center of
the bottom of the plasma display then slowly insert them
directly into the slots. Be extremely careful not to insert the
support columns of the stand into any part of the plasma
display other than the stand insertion slots. Note that doing
so might damage the plasma display panel or its ports or
result in the warping of the stand.
2
Securing the plasma display with attach-
ment screws 2.
Secure them using the enclosed hexagonal wrench.
4
En
Line up the column
supports with the bottom
of the plasma display as
indicated in the accompa-
nying diagram.
Attachment screw 2
3
Securing the plasma display with attach-
ment screws 3.
Secure them using the enclosed hexagonal wrench.
4
Attaching the speakers.
Refer to the operating instructions for the speaker for
the installation method.
Attachment
screw 3