Bycool COMPACT3.0 Instructions De Montage page 31

COMPACT
VEHICLES WITH ORIGINAL HATCH OR PRE-MARKING IN THE ROOF FOR
Position the console and align the equipment
15a
in the most suitable location in the cabin roof.
Once aligned, remove the console.
Secure the attachment supports by turning the
15b
nuts to tighten the exterior EPDM seal of the
equipment between 3 mm and 6 mm.
Important: The EPDM seal must be tightened
with the base of the Compact, as shown in the
diagram, in order to prevent any leakages of
water inside the cabin.
3-6mm.
Cabin roof
Fasten selflocked nut until
15b EPDM gasket is compressed
between 3 and 6 mm.
Tighten (4) M8 nuts to the support piece and
15c
(4) to the base of the Compact.
INSTALLATION OF THE HATCH
EPDM gasket
10 mm*
(*) (approx. after tightening)
Base
Bracket
31
Check the
compression of the
EPDM seal using
a flexometer in the
four corners.
EPDM gasket
EN ES
®
15b
15b
15c