Bycool COMPACT3.0 Instructions De Montage page 30

COMPACT
ES
EN
Position the interior air distribution panel
14
on the front studs with (1) M6 wide-rimmed
washer and (1) M6 nut on each stud. Tighten
the nuts until the interior air distribution panel
duct comes up against the unit's top foam.
Important: The interior air distribution
panel duct must come up against the
unit's upper foam in order to prevent any
leakages of air.
Take care to ensure the cables do not
become trapped between the duct and the
foam in the base of the unit.
14
EPDM
Gasket
Cabin roof
Upholstey
Tighten the nut in point 12 until it comes up
15
against the top part of the interior air distribution
panel.
15
EPDM
Gasket
Cabin roof
Upholstey
Base Compact
M6 Nut
M6 stud
Base Compact
M6 Nut (12)
M6 Nut
M6 stud
Interior air distribution panel
Interior air distribution panel
30
Foam
Foam
®