Bycool COMPACT3.0 Instructions De Montage page 24

COMPACT
ES
EN
HOW TO CUT EPDM GASKET
!
TO AVOID WATER FILTRATION
A- Glue gasket, keeping 100 mm of protection
paper at each side.
B- Remove the two pieces of paper.
C- Glue by pressing both ends.
B
Gasket
VEHICLES WITH ORIGINAL HATCH OR PRE-MARKING IN THE ROOF
CABIN EXTERIOR:
5
Position the Compact in the hatch gap.
Caution! When positioning the unit above
the hatch gap, check that the wastewater
run-offs are not blocked by the EPDM
seal.
INTO THE CABIN
Gasket
Remove
FOR INSTALLATION OF THE HATCH
A
Gasket
100 mm Approx. (protection paper)
C
Gasket
Sun hatch
24
®
15 mm
Gasket
Cabin roof
Gasket
5