Publicité
Les langues disponibles
Les langues disponibles
Instructions for use
The EVOLUTWIN stroller includes two seats,
two hoods, two bumper bars, two raincovers
and a basket.
1. UNFOLDING THE STROLLER
-
Press on the button on the articulation of the
left chassis (1).
-
Raise the handlebars until the stroller is
unfolded completely (2 and 3).
WARNING
: Make sure the chassis is firmly
locked in place (click heard).
2. PARKING BRAKE
It blocks the rear wheels.
-
To block the rear wheels, press your foot on
the pedal to apply the brake (located to the
right) (4a).
-
To release the brake, raise the pedal with your
foot (4b).
WARNING
: It may be dangerous to leave
your child alone and unattended, even if the
brake is applied.
WARNING
: Check that the wheels are
properly blocked.
3. USING THE STROLLER
INSTALLING / REMOVING THE TWO SEATS
-
Extend the two telescopic tubes by pressing
on the white buttons (5 and 6).
WARNING
Make sure that the telescopic
tubes are securely locked in place (click
heard).
-
The seats can be positioned to be front or rear
facing. Refer to the table for the configurations
possible (pages 6, 7 et 8).
-
In the double stroller configuration, with
two seats, we recommend that you install
the lower seat first (7).
-
To position a seat in place, line up the sides of
the seat with the sockets on the chassis and
set the seats in place (8 and 9).
WARNING
: Make sure that the seats are
firmly engaged (click heard).
-
To remove the seats, press on the white
buttons on the sides of the chassis, lift up and
remove the seats (10).
REMOVABLE BUMPER BARS
-
Fit the bumper bars into the slots provided for
them until clicks heard (11).
-
To remove, press on the white buttons below
the bumper bars and pull towards you (12).
WHEELS
-
Enclench the wheel vigorously in place, check
that it is well secured by pulling on it, towards
you (13).
-
To remove, press on the white buttons (14)
and pull the wheels outwards.
SAFETY HARNESS
The EVOLUTWIN stroller includes a 5 point
harness.
-
To adapt it to fit, adjust the length of both
shoulder straps to the child's size (15).
-
Insert the two buckles into the crotch buckle
until it is locked securely in place (click heard)
(16).
-
To release, press on the button (17).
-
The shoulder pads are adjustable at 3 heights
thanks to the press studs on the shoulder straps
(18).
-
The shoulder straps are height adjustable.
To adjust their height:
-
Unzip the back seat cover (19).
-
Undo the hood supports at either side of the
seat in order to access underneath the seat
cover (20). Undo the seat back cover in order to
access the structure below the seat (22).
-
Undo the strap buckle (21).
-
Undo and remove the harness' shoulder straps
by slipping them through the slots on the seat
then back through other slots at the desired
height (22).
-
Replace the hood supports at either side of the
seat.
GB
32
Publicité
