Setup And Special Configurations - Midland BTX1 PRO Guide D'utilisation

Masquer les pouces Voir aussi pour BTX1 PRO:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

FM Radio with intercom
When you are in "FM Radio" mode is not possible to manually open the intercom, you
can only open it using VOX feature (just talk) to the unit paired on the "Middle" button.
To manually activate the intercom you must switch to "Intercom" mode.
How to Disable/Enable the FM Radio
By default the FM radio is on.
Disabling:
› Enter the "Setup" mode: turn off the unit and hold down the "Middle" button about 7
sec., until the Red light is on permanently.
› Press "Middle" and "Volume+" buttons together for 3 seconds. The blue LED will
flash three times.
› Double click on the "Middle" button to exit the "Setup" mode and use the BTX1 PRO.
Enabling:
› Follow the same procedure up described; now the blue LED will flash once.
› To exit the "Setup" mode, double click the "Middle" button.
Pairing to a PMR446 radio with integrated or external Bluetooth
The PMR446 Radio can be paired to the "Volume +" or "Volume -" button. If paired on
"Volume -" and the "Background" feature is activated, the PMR446 radio is always in
the background even when you talk on the intercom.
Pairing procedure
› Turn off the unit
› Press and hold down the "Middle" button about 7 sec., until the Red light is on per-
Radio FM mode
Mode
Forward button
FM Radio
Short press: seek station up
Long press: Scan recorded
10
manently.
› Now press firmly (3 sec) the "Vol +" or "Vol -" button, the Blue and Red light will
flash.
› Follow now the pairing procedure explained on the manual of the transceiver itself.

Setup and special configurations

Resetting all paired devices
Sometimes you may find it necessary to delete all the pairing references stored in the
BTX1 PRO unit (reset operation).
To perform this operation you must first enter the setup mode:
› Turn off the unit
› Press and hold down the "Middle" button about 7 sec., until the Red light is on per-
manently.
› Then simultaneously press and hold down the "Volume +" and "Volume –" buttons for
3 seconds. The Blue Light will be lit on for 1 sec and then back to steady RED.
› Double click on the "Middle" button to exit the "Setup" mode and use the BTX1 PRO.
This procedure deletes all the paired Bluetooth devices stored in the memory therefore
you will not have "Phone" and "Intercom" mode, only "FM Radio" mode will be available.
Back to factory setting
Sometimes you may find it necessary to go back to the factory setting, to reset all the
changes/setup already made and have a "clean" unit.
To perform this operation you must first enter the setup mode:
› Turn off the unit
› Press and hold down the "Middle" button about 7 sec., until the Red light is on per-
Middle button
Short press: On/off
Long press: Change mode
Backward button
Short press: seek station down
Long press: Scan recorded
www.midlandeurope.com

Publicité

Table des Matières
loading

Table des Matières