Boom Microphone - Midland BTX1 PRO Guide D'utilisation

Boom Microphone

Place the section with the Velcro/adhesive strip between the padding and the rigid cover
of the helmet, so that the microphone is correctly positioned in front of your mouth and
that the white symbol is facing your mouth. This type of microphone is suited for Open
Faced and Flip Front helmets.
Wired microphone
Using the Velcro/adhesive strip, place the microphone inside the helmet in front of your
mouth. This type of microphone is more suited for Full Faced helmets. The mini con-
nector on the microphone allows you choose the microphone that best suits the helmet
you are using.
Description of the Slide-in mounting kit
To fix the Midland BTX1 PRO onto the helmet, you have to install the slide-in mounting
kit by using the plate with bi-adhesive strip. This method allows you to safely "fix" the
BTX1 PRO unit onto your helmet and to remove it at any time in order to recharge or
store it.
4
Plate with bi-adhesive strip
The Bi-adhesive plate is already assembled on the slide-in mounting kit.
Bi-adhesive
Clean the application area on the helmet surface, remove the bi-adhesive film and place
the fixing plate on the left side of the helmet by keeping it contact with the surface for
a few seconds.
Fitting and removing your Midland BTX1 PRO
The BTX1 PRO can be easily fitted onto the helmet by sliding it downwards on the sliding
mounting kit. BTX1 PRO is maintained in position thanks to the fixing clip located on the
upper section (A). To detach the BTX1 PRO, simply press the fixing clip and push the
unit upwards.
Lock Unlock
A
www.midlandeurope.com