Quick CHC 1102 M Manuel De L'utilisateur page 7

INSTALLING THE SOCKET
The standard installation procedure is described below.
Unfortunately we cannot describe a procedure applicable to all types of windlasses. Adapt this procedure
to satisfy your own individual requirements.
Find the spot most suitable for the socket based on the following criteria:
• The socket is to be installed in an area where it can be easily reached by the user.
• Select a clean, smooth, flat spot.
• A rear point that provides access to the socket's fixing surface must be present for installation and
maintenance purposes.
• Leave enough space free behind the installation spot to conveniently run the socket's cable.
• The back of the socket must be protected against contact with water and moisture.
• Pay careful attention when drilling the panel or parts of the boat. This hole should not weaken or break/
crack the boat's structure.
The chain counter meets standard EMC (electromagnetic compatibility). In any case correct installation is
fundamental in order not to affect its performance or interfere with operation of instruments found near it.
For this reason the chain counter must be at least:
• 25 cm away from the compass.
• 50 cm away from any radio receivers.
• 1 m away from any radio transmitters (except for SSB).
• 2 m away from any radio transmitters SSB.
• 2 m away from the path of the radar beam.
Installing the socket
After selecting the area where the instrument is to be
installed, perform the steps given below:
• Place the drilling template (provided) on the surface where
the socket will be installed.
• Mark the center of each hole.
• Make the hole for the passage of the cable of the socket
with a milling cutter (25 mm / 1").
• Remove the template and any burrs present in the hole.
• Place the seal at the base of the socket.
• Run the cable through the hole made.
• Fix the socket tightening the 4 screws provided.
CHC1102M GB F - REV005B
INSTALLATION
GB
7