Quick CHC 1102 M Manuel De L'utilisateur page 14

CHAIN COUNTER OPERATION
GB
WINDLASS ELECTRIC DRIVE
Getting the anchor aweigh
To get the anchor aweigh press key
anchor reaches the desired position and then release it.
While moving up, the chain counter displays a window similar to the one
shown below:
It is also possible to get the anchor aweigh with an other electric control. The
chain counter will measure the length of the chain lowered in any case.
Lowering the anchor
To lower the anchor press key
anchor reaches the desired position and then release it.
While moving down, the chain counter displays a window similar to the one
shown below:
It is also possible to lower the anchor with an other electric control. The
chain counter will measure the length of the chain lowered in any case.
Automatic down function
This function can be used only if it was previously set and activated on the FUNCTIONS\AUTO DOWN
menu (see chapter SETTING THE CHAIN COUNTER).
ATTENTION: regular operation of the windlass has to be checked
when moving down automatically
To lower the anchor automatically to the set depth, press keys
q
and (DOWN) simultaneously for more then three seconds.
Once the procedure has started, both keys can be released. The chain
counter will lower the anchor to the set depth.
While moving down automatically, the chain counter displays a window
similar to the one shown below:
The automatic lowering procedure can be interrupted by pressing any key of the chain counter from whi-
ch the procedure was activated, by activating the up function from an external device (from another chain
counter or other control) or by shutting off the chain counter.
14
p
(UP). Hold the key pressed until the
q
(DOWN). Hold the key pressed until the
=
(SELECT)
CHAIN UP
SPEED 20 M/M
CHAIN DOWN
SPEED 20 M/M
AUTO DOWN
SPEED 20 M/M
CHC1102M GB F - REV005B