Installing The Terminals - Quick CHC 1102 M Manuel De L'utilisateur

INSTALLING THE TERMINALS

In order for data to be correctly transmitted when several chain counters are employed, terminator (150
ohm) must be installed.
The terminator should be connected between signals CANH and CANL of the first and last chain counter
included in the network, as illustrated in the figure below:
UP ALARM
SPEED 000 M/M
20
150
Do not install the terminator if just one chain counter is used.
CHC1102M GB F - REV005B
150
1
19
INSTALLATION
2
18
GB
3
17
INSTRUMENTS
FROM 5 TO 16
11