Quick CHC 1102 M Manuel De L'utilisateur page 20

SETTING THE CHAIN COUNTER
GB
SETTINGS MENU - FUNCTIONS - AUTOMATIC DOWN
The automatic down function is enabled or disabled with this option. This function allows the anchor to
automatically move down to the set depth (see chapter CHAIN COUNTER OPERATION paragraph AUTO-
MATIC DOWN FUNCTION).
ATTENTION: the chain counter is not able to compensate for mechanical inertia of the windlass
(the gypsy can rotate downward direction as soon as the command has been inactivated). Take
this factor into consideration when setting the automatic down value.
ATTENTION: even if the automatic down function is enabled, the user must always pay careful
attention and make sure the anchor is correctly lowered.
AUTO DOWN
SET VALUE:
OFF
AUTO DOWN
SET VALUE:
5 M
PERSONAL SET
CONTRAST
LIGHT
LIGHT DELAY
KEY BEEP
LOCKED KEYS
EXIT
20
Examples of the windows used for the automatic down function are
shown below:
default: OFF
If the unit of measurement is set to METERS, the settable values are OFF,
from 5M to 100M with 5M steps.
If the unit of measurement is set to FEET, the settable values are OFF, from
15FT to 300F with 15FT steps.
Increase value
Decrease value
Confirm value and go back to FUNCTIONS menu.
SETTINGS MENU
PERSONAL SET
This option allows the user to enable and set several functions to per-
sonalize the chain counter.
The PERSONAL SET sub-menu is shown below.
Selects the data items in the sub-menu.
Press this key to go to the menu shown in REVERSE; if EXIT has been
selected the system goes back to the SETTINGS menu.
CHC1102M GB F - REV005B