Becker Centronic VarioControl VC210 Notice De Montage Et D'utilisation page 30

Programming additional transmitters
In addition to the master transmitter, up to 15 further trans-
mitters can be programmed in the radio receiver for both the
lighting system and the heating element.
Press the programmed master transmitter's programming button for 3
seconds.
▻ The receiver confirms.
Now press the programming button of a new transmitter which has not yet
been programmed in the radio receiver for 3 seconds. Doing so activates the
programming mode of the radio receiver for a new transmitter for 3 minutes.
▻ The receiver confirms.
Now re-press the programming button of the new transmitter you wish to pro-
gram for 3 seconds.
▻ The receiver confirms.
► The new transmitter has now been programmed.
30 - en