Becker Centronic VarioControl VC210 Notice De Montage Et D'utilisation page 29

Program the master transmitter for the lighting system
a) Putting the radio receiver into programming mode by switching on
the power
Switch on the power.
► The radio receiver remains in programming mode for 3 minutes.
Now press the programming button of the transmitter for 3 seconds whilst in
programming mode.
► The receiver confirms.
Programming is now complete.
b) Putting the radio receiver into programming mode with the program-
ming button
Press the "Lighting system" programming button on the radio receiver for
3 seconds.
► The radio receiver remains in programming mode for 3 minutes.
Now press the programming button of the transmitter for 3 seconds whilst in
programming mode.
► The receiver confirms.
Programming is now complete.
Program the master transmitter for the heating element
Press the "Heating element" programming button on the radio receiver for
3 seconds.
► The radio receiver remains in programming mode for 3 minutes.
Now press the programming button of the transmitter for 3 seconds whilst in
programming mode.
► The receiver confirms.
Programming is now complete.
29 - en