Publicité
Les langues disponibles
Les langues disponibles
Safety devices on the product
WARNING:
instructions that follow before you use
the product.
•
Do not use a product with defective safety
devices. Do a check of the safety devices
regularly. If the safety devices are defective,
speak to your Husqvarna service agent.
•
Do not make modifications on safety devices. Do
not use the product if protective plates, protective
covers, safety switches or other protective
devices are not attached or are defective.
To engage and disengage the Roll Over Protection
Structure (ROPS)
•
Remove the 2 pins that hold the ROPS and fold it
rearwards to disengage. Engage the ROPS in
the opposite sequence.
WARNING:
instructions for the ROPS and the
safety belt.
•
Do not use the safety belt if the ROPS is
disengaged.
•
Always use the safety belt when the ROPS is
engaged.
•
Make sure that the ROPS is correctly attached
and not damaged.
To do a check of the ignition lock
•
Start and stop the engine to do a check of the
ignition lock. Refer to
13 and To stop the engine on page 14 .
•
Make sure that the engine starts when you turn
the ignition key to start position.
•
Make sure that the engine stops immediately
when you turn the ignition key to stop position.
Operation conditions
These conditions are necessary to start the engine:
•
The control levers are in the neutral position.
•
The parking brake is applied.
•
The drive of the blades is disengaged.
1741 - 001 - 08.11.2021
Read the warning
Obey the following
To start the engine on page
•
The OPC is pushed down.
The engine must stop in these situations:
•
The parking brake is not applied and the operator
lifts from the seat.
•
The drive of the blades is engaged and the
operator lifts from the seat.
Try to start the engine without 1 of the conditions.
Change the conditions and try again. Do this check
daily.
Parking brake
WARNING:
does not work, the product can start to
move and cause injury or damage. Make
sure that the parking brake is regularly
examined and adjusted.
To do a check of the parking brake on page
Refer to
18 .
Muffler
WARNING:
if the muffler is missing or defective. A
defective muffler increases the noise
level and the risk of fire.
The muffler keeps the noise levels to a minimum and
sends the exhaust fumes away from the operator.
Examine the muffler regularly to make sure that it is
attached correctly and not damaged.
WARNING:
very hot during and after use and when
the engine operates at idle speed. Be
careful near flammable materials and/or
fumes to prevent fire.
To do a check of the muffler
•
Examine the muffler regularly to make sure that it
is attached correctly and not damaged.
Spark arrestor
This product has an internal-combustion engine. Do
not use the product near vegetation without a spark
arrestor that is approved by local or state laws.
Federal laws apply on federal lands.
A spark arrestor for the muffler is available through
your approved Husqvarna dealer.
Protective covers
Missing or damaged protective covers increase the
risk of injury on moving parts and hot surfaces. Do a
check of the protective covers before you operate
the product. Make sure that the protective covers are
correctly attached and do not have cracks or other
damages. Replace damaged covers.
If the parking brake
Do not use the product
The muffler becomes
9
Publicité
