LEMAN MOR750 Manuel D'utilisation page 58

2. Place workpiece on table and clamp it with the vise. Use the left handwheel to move table
forward or backward to suit the position of the mortise on the workpiece.
3. Adjust the table stops, Figure 5, according to the length of cut required, then tighten the thumb
screws.
FIGURE 5
4. Turn on machine and feed chisel and bit steadily into workpiece by pulling down the operating
handle.
NOTE: The rate of feed must be fast enough to prevent burning at the tip of the bit, but not so fast
as to cause the machine to slow or stall. The different rates of feed for different woods must be
learned through experience.
5. After the first cut, the workpiece is moved along with the right handwheel for each successive
cut. The direction of movement must allow the chips to clear freely. Move the workpiece so that
the slot in the chisel is releasing chips into the already cut part of the workpiece. See Figure 6.
EN