LEMAN MOR750 Manuel D'utilisation page 53

Use proper tool. Don't force tool or attachment to do a job for which it was not designed.
Wear proper apparel. Do not wear loose clothing, gloves, neckties, or jewelry that can get
caught in moving parts. Nonslip footwear is recommended. Wear protective hair covering to
contain long hair
Use safety glasses. Also use face or dust mask if cutting operation is dusty.
Secure work. Use clamps or a vise to hold work when practical. It's safer than using your hand
and frees both hands to operate tool.
Don't overreach. Keep your proper footing and balance at all times.
Maintain tools in top condition. Keep tools sharp and clean for best and safest performance.
Follow instructions for lubricating and changing accessories.
Disconnect tools before servicing and when changing accessories such as chisel and bit.
Use recommended accesories. Consult the owner's manual for recommended accessories.
The use of improper accessories may cause hazards.
Avoid accidental starting. Make sure switch is in "OFF" position before plugging in cord.
Never stand on tool. Serious injury could occur if the tool is tipped or if the cutting tool is
accidentally contacted.
Check damaged parts. Before further use of the tool, a guard or other part that is damaged
should be carefully checked to ensure that it will operate properly and perform its intended
function - check for alignment of moving parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
Never leave tool running attended. Turn power off. Don't leave tool until it comes to a complete
stop.
Drugs, alcohol, medication. Do not operate tool while under the influence of drugs, alcohol, or
any medication.
Health hazards. Some dust created by power sanding, sawing, grinding, drilling and other
construction activities contains chemicals known to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
- Lead from lead-based paint.
- Crystalline silica from bricks and cement and other masonry products.
- Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To
reduce your exposure to these chemicals, work in a well-ventilated area, and work with approved
safety equipment, such as those dust masks that are specifically designed to filter out
microscopic particles.
EN