Abus HDCC81000 Manuel Utilisateur page 35

SYS INFO SETTINGS
SOFT ADDRESS
SOFT ADDR ACT
SOFT BAUD
SOFT BAUD ACT
BROADCAST ADDR
PELCO CHECKSUM
SYS TIME
BACK
Function
SOFT ADRESS
SOFT ADDR ACT
SOFT BAUD
SOFT BAUD ACT
BROADCAST ADDR
PELCO CHECKSUM
SYS TIME
1
OFF
2400
OFF
ON
ON
EXIT
Description
(1-255): Dome ID for using control via the RS-485 protocol.
Alternatively, the ID can be set using DIP switches.
OFF: Deactivation of the software dome ID
ON: Activation of the software dome ID
(2400-19200): Baud rate setting for the RS-485 interface.
Alternatively the baud rate can be set using DIP switches.
OFF: Deactivation of the baud rate setting via OSD
ON: Activation of the baud rate setting via OSD
ON: If the control unit has the ID 0 all cameras connected to the
bus can be controlled.
OFF: Function deactivated
Only applies if the Pelco D/P protocol is being used.
ON: Checksum test following each control command
OFF: Test deactivated
Settings for date and time
35