Publicité
Les langues disponibles
Les langues disponibles
Mounting
In connection with the axial movement of the propeller shaft a
minimum free space between outer bearing and propeller hub is
required.
Propeller-thrust
N.B. When sailing in forward direction the rubber part must be com-
pressed.
Using the Uniflex in combination with a V-drive type gearbox is not
allowed!
Over-size (larger) propeller shaft diameter
Reduce the propeller shaft diameter for the taper length (dimension
'A') to the given dimension 'd' of the coupling, see 'Overall dimen-
sions'. Radius 'r' minimal 2 mm (0.08").
4
030203.02
Misalignment
The maximum allowable
misalignment of the pro-
peller shaft is 2°.
General assembly
To achieve a reliably operating coupling all the bolts and nuts must
be tightened with the torques given. Use a torque wrench; tighten-
ing it 'in the blind' will not lead to satisfying results.
M8 x 25, UNIFLEX TYPE 13
M12 x 35, UNIFLEX TYPE 16
Grease the outside of the taper and the bolts.
Tightening torque:
45 Nm (4.5 kg.m, 33 lbs.ft)
Tightening torque:
45 Nm (4.5 kg.m, 33 lbs.ft)
Flexibele schroefaskoppeling UNIFLEX
Publicité
