Storch WAMAB Mode D'emploi page 50

Feed fitting kit for WAMAB, Item No. 61 20 01
Is used for the optimum installation of the water feed for operating the WAMAB with a STORCH separating system.
Two water inlets are mounted on an assembly plate here, one for connecting to fresh water and one for connecting to
the circuit water of the separating system as well as two water outlets. The spray kit and a high-pressure cleaner (e.g.,
for operation with Turbo-Wash) can be connected. When operating the two ball valves, the water feed can be set to
fresh or circuit water and can be forwarded to the spray kit or the high-pressure cleaner.
Turbo-Wash for WAMAB, Item No. 61 20 50
Paint roller cleaner for fixed installation to the WAMAB and for connecting to
a high-pressure cleaner. The water consumption per paint roller sinks to 7 litres
and the cleaning time is less than 1 minute. The rollers are subsequently spun
due to the high speed of the rollers during cleaning and come out of the device
almost dry. Robust professional device, rust-proof.
4. Spare parts
Designation
Drain fitting 70 mm, 1 1/2"
Ball chain for the drain plug
Screw cover 92, top left
Screw cap 50, with seal
Sealing plug for the sedimentation vessel
Filling level display with seal
Seal settling tank / wash basin
Drain cock 3/4", bottom left
Three-pin earthed plug for immersion pump 65 77 16
Wash area for pasting machines
Translation of the original instruction
Designation
Item No.
Wash basin, small
61 20 14
Spray head
61 20 15
Reduction 1/2" male thread
61 20 29
x 3/4" female thread
61 20 30
Spray hose
61 20 32
Spray holder
61 20 35
Screw support 92, threaded
61 20 36
Screw cap 92, drilled
61 20 37
Siphon
Transition hose piece
61 20 20
Siphon paste drain
Rubber tensioning strap set for WAMAB
50
Item No.
61 20 21
61 20 11
60 63 31
61 20 13
61 20 46
61 20 22
61 20 42
61 20 43
61 20 12
61 20 06
61 20 25