Télécharger Imprimer la page

Thule OMNISTOR Omni-Step Slide Out Mode D'emploi page 2

Publicité

- Achten Sie darauf das während des fahrens dieTrittstufe
sachmässig eingefahren wird und verriegelt ist.
Read these instructions carefully. No guarantee will be
allowed for wrong installation or use.
In order to meet the EN 1646-1 (motorhomes) and EN
1645-1 (caravans) requirements, when extended, the step should not
be higher than 400 mm from the ground and should be between 200
and 300 mm from the next step.
CONTENT MOUNTING SET
Bracket ...................................................................................4
Hex bolts DIN 933 - M8 x 55 ...................................................4
Washers DIN 125 - M8 ...........................................................8
Safety nuts DIN 985 - M8 .......................................................4
Self drilling screws DIN 7504 – 4,2 x 16 ..................................4
Plate screw DIN7981 6,3 x 32 .................................................2
INSTALLATION
These installation instructions are suggestions only. The mounting
surface has to be flat in order to obtain a perfect functionning of
the step. The rails need to be perfectly parrallel.
- Slide the brackets onto the left - and the right hand side of the
Omnistep (fig.2). This can be done at four different heights
(fig.3).
- Slide the brackets as far as possible from each other (min
230mm) and fix them with the self drilling screws 4,2x16. Predrill
Ø3,5. Fig. 4.
- Drill 4 holes diam. 9 mm according to the coordinates shown in
fig.1. Only the rear brackets may eventually be fixed with the
delivered plate screws 6,3x32. Predrill Ø3,5.
- Fix the step. Fig. 5.
REMARK: If the underground on which the step is installed is
made of soft material, use an intermediate plate (A) and/or tubes
(B) to fill out. See fig. 6.
OPERATION
OPEN
- Unlock the footboard by tilting up the lock profile under the
footboard. Fig 6.
- Pull at the footboard till the back lock has hooked in.
- Remark: For your safety, never mount on the step when the
footbard is not locked.
CLOSE
- Lift up the footboard to unlock it.
- Push the footboard till the front lock has hooked in.
- Check if the step is retracted and locked before departure.

Publicité

loading