Tristar SZ-1912 Mode D'emploi page 16

Two options
It is easy to change from dust tank to dust bag. Pull out the dust tank and replace this by the dust bag
holder. You just have to push in the holder of the dust bag and you can start vacuuming with dust
bag.
Cleaning the dust container
•
Open the front cover by pressing the lock clip.
•
Lift the dust container from the dust cabinet by dust
container handle
•
Carry the dust container over dust bin. Press the dust
release button on bottom of
dust container & empty dust container.
•
To clean the HEPA filter inside of dust container. Please
clock-wise turn off the HEPA filter.
Clean the HEPA filter by using a brush.
•
Reset the HEPA filter and dust cover. Place the dust
container into the dust cabinet. Make sure the dust
container has well fit inside of dust cabinet.
Replacing the dust bag
When the dust bag is full (you can check it by the indication light), it is time to replace the dust bag.
To do that, please follow the instructions:
•
Open the front cover by pressing the lock clip
•
Lift off the Paper bag from dust bag hold. Please always keep the dust inlet hole upper in
order to void dust leakage.
•
Replace the dust bag and install a new dust bag to the holder. Make sure the card of dust bag
reach to the bottom of dust holder.
•
Close the front cover.