LaserLiner CenterScanner Plus Mode D'emploi page 11

4
Metal detection
The tool is able to detect hidden metal in all non-metallic materials, e.g. brick, concrete, screed,
wood, plaster fibreboard, gas concrete, ceramic and mineral building materials.
1. Switch on device and slowly move it over the surface (see Fig. d). The LED indicators (2) show
if there is metal close by. Mark the spot when all indicators are on.
2. Repeat step 1 (see Fig. e).
5
Voltage detection
For localising live wires directly beneath the plaster or behind wooden panels and other non- metallic
panelling. It is not possible to detect live wires in dry walls with metal studs.
6
Offset measurement
1. Move the transmitter TX in an area where there is no metal and measure the distance from
the transmitter TX to the required drilling point (see Fig. g).
2. Determine the position of the transmitter TX with the receiver RECV on the other side (see Fig. h).
3. Transfer the measured distance (step 1) in the direction of the required drilling point (see Fig. i).
d
Switch on device and slowly move it over the surface (see Fig. f).
f
The LED indicators (3) show if there is a live cable close by.
g
CenterScanner Plus
e
h i
11
EN