Electrical connection
Risk of electric shock!
The appliance features an EU safety plug.
To ensure protective earthing in a Danish
socket, the appliance must be connected to
a suitable plug adapter. This adapter (per-
mitted up to max. 13 amps) is available from
customer service (spare part no. 616581).
The mains power supply must correspond
to the rating indicated on the plate situat-
ed inside the hood. If provided with a plug
connect the hood to a socket in compliance
with current regulations and positioned in
an accessible area. If it not fitted with a plug
(direct mains connection) or if the plug is not
located in an accessible area apply a bi-polar
switch in accordance with standards which
assures the complete disconnection of the
mains under conditions relating to over-cur-
rent category III, in accordance with installa-
tion instructions.
Warning! Before re-connecting the hood
circuit to the mains supply and checking
the efficient function, always check that the
mains cable is correctly assembled.
Warning! Power cable replacement must be
undertaken by the authorized service assis-
tance centre or similar qualified person.
Connect the hood to a norm complying plug
only.
The plug should be located in an accessible
zone.
■ The plug must be equipped with a protec-
tion circuit.
■ If after installation the plug can not be
reached, a disconnecting device must be
envisaged.
Fixed installation:
The fixed installation can be carried out
by a qualified and authorized person only.
Envisage an omnipolar switch having a
contact opening of at least 3mm, including
an automatic circuit breaker.
The cable must be replaced by the manufac-
turer, the assistance centre or a qualified and
authorized person only, in order to avoid any
dangers.
Electrical data:
The technical data of the device are on the
distinctive label inside the device behind the
grease filters.
In case of repair, disconnect the electric
supply from the cooker hood.
Length of the feeding cable: 1,30m.
The hood complies with the EMC directive.
11