Matrix PGT 3 in 1 Traduction De La Notice Originale page 69

Important!
Always pull out the spark boot plug each time
before carrying out any cleaning. Never immerse
the equipment in water or other liquids in order
to clean it.
Store the chainsaw in a safe and dry place out of
the reach of children.
Storage
Important: Never put the equipment into storage
for longer than 30 days without carrying out the
following steps.
Storing the equipment
If you intend to store the equipment for longer
than 30 days, the equipment must be prepared
accordingly. Otherwise the fuel still remaining in
the carburetor will evaporate and leave rubbery
sediment. This can cause problems when starting
up the equipment and may require expensive
repairs.
1. Slowly remove the fuel tank cap to release
any pressure that may have formed in the tank.
Carefully empty the tank (7).
2. To remove the fuel from the carburetor, start
the engine and let it run until the equipment
stops.
3. Leave the engine to cool (approx. 5 minutes).
4. Remove the spark plug.
5. Add one teaspoon of 2-stroke engine oil into
the combustion chamber. Slowly pull the starter
cord several times to apply a layer of oil to all
internal components. Fit the spark plug again.
Note: Store the equipment in a dry place and
far away from possible ignition sources such as
an oven, a gas-fired hot water boiler, a gas-fired
dryer, etc.
Putting the equipment back into operation
1. Remove the spark plug.
2. Quickly tug on the starter cord to remove
excess oil from the combustion chamber.
3. Clean the spark plug and check that the
electrode gap is correct, or insert a new spark
plug with the correct electrode gap.
4. Prepare the equipment for operation.
5. Fill the tank with the relevant mixture of fuel
and oil.
Transport
To transport the machine, empty the petrol tank
as described in section 10. Clean coarse dirt off
the equipment with a brush or hand brush.
Dismantle the drive rod mechanism as described
in section 5.2.
For the Combined gasoline grass trimmer, pole
saw, brush cutter works fine again after a long
storage period, you should note the following:
- Empty the fuel tank (7) before storage.
- Start the engine and let it run until it stops.
- If the engine is cool, remove the spark plug.
- Fill a small bucket 2-stroke mixture into the
spark plug hole and pull the rope slowly several
times. This soot is blown out and lubricated
piston and cylinder.
- Keep the Combined gasoline grass trimmer,
pole saw, brush cutter in a dry place, out of reach
of children and do not catch fire.
8.5 Restart after longer breaks
1 Check the spark plug, replace it if necessary,
and screw it into the hole.
2 Pull the cable through times rapidly to clean
the engine compartment of oil and debris.
3 Fill the fuel tank with mixing ratio of 40:1. Start
as described in 5.1.
69