Matrix PGT 3 in 1 Traduction De La Notice Originale page 51

- Attach the cutter protection (15)
with the 4 screws on the holder on
the shaft (if not already fitted). In
addition, the protective cover must
be fitted with knife on cutting
protection.
- Use a screwdriver, or the supplied
Allen key (28) to fix the shaft of the
29
petrol brush cutter at the intended
location by a locknut.
- Use the supplied spark plug
wrench (29) to loosen the
hexagonal screw for attachment of
the cutting blade by turning it in
clockwise direction.
- Remove the hex nut (14), and the
retaining plate (16) for the brush
cutter. Keep these parts well.
- attach the support flange (17),
clamping flange (13) on the shaft.
- Use a screwdriver, or the supplied
Allen key (28) to fix the shaft of
the petrol cutting blade at the
intended location by a locknut.
- Turn the line spool (18)
counterclockwise on the shaft.
WARNING: left-handed thread
Remove the transport cover.
Connect drive unit with a trimmer.
Pull this end of the locking bolt
(26). Make sure that the locking
bolt (26) engages into the locating
hole (a). Finally, locking screw (10)
securely.
51