Flexible Shaft; Stretch Stand For The Multi-Function Tool - Parkside PFBS 160 A1 Instructions D'utilisation Et Consignes De Sécurité

Start-up
Examples of use / selecting the correct tool
Function
Drilling
Milling
Engraving
Polishing, rust
removal
CAUTION!
Only apply the tool
to the work piece
under light pressure.
Cleaning
Grinding
Cutting

Flexible shaft

Never use the spindle lock with the motor on.
The tool or the flexible shaft could otherwise
be damaged.
Unscrew the union nut
counter-clockwise, and put aside.
Press and hold the spindle lock
Unscrew the clamping nut
turning counter-clockwise.
Attach the flexible shaft to the tool, inserting the
inner axle on the flexible shaft along with the
clamping nut into the collet
6
First tighten the clamping nut
nut of the flexible shaft
13 b
ing clockwise.
Now insert the accessory you wish to use into
the collet of the flexible shaft.
7
42 GB
Accessory
Drill bit
28
Milling bit
27
Engraving bits
26
Metal brush
31
Polishing tools
22
Plastic brushes
30
Metal brush
31
Grinding discs ,
19 21
Grinding stone ,
23
Grinding bits
20
Sanding belts
24
Cutting discs
18
from the tool, turning
5
.
8
from the tool,
6
.
7
, then the union
6
to the tool, turn-
13
Application
Wood applications (see Fig. C)
Various applications; e.g. recessing, hollowing
out, shaping, grooving, or making slots
Marking (see Fig. D)
Rust removal (see Fig. E)
Processing various metals and plastics, particularly
precious metals such as gold or silver (see Fig. F)
e.g. cleaning hard to reach plastic housings or
cleaning the area around a door lock
e.g. rust removal (see Fig. E)
(The metal brush is softer than steel)
Grinding stone, detail work on hard materials such
as ceramics or alloy steel (see Fig. G)
Sanding wood
Processing metal, plastic (see Fig. H)
To lock the spindle, slide back the black sleeve
on the flexible shaft.
Using the combination wrench
collet holder on the flexible shaft, insert the
14
accessory and tighten the collet holder
Stretch stand for the multi-
function tool (Fig. I)
Screw the stretch stand
Note: The stretch stand
into the clamp in two different positions, de-
pending on the whether you're attaching to a
horizontal or vertical surface.
Secure the clamp
17
bench or a work table no thicker than 55 mm.
, open the
33
.
14
into the clamp
16 17
can be screwed
16
at the edge of a work-
.