Abicor Binzel TCS Compact Mode D'emploi page 63

TCS Compact
6.4.1 Height adjustment
 Fig. 21 Setting up the pneumatic motor on page EN-26
4
5
9
4 Gas nozzle
5 Reamer
Fig. 22
Height adjustment
NOTICE
• The device has to be depressurized during set-up.
1 Use the AF6 Allen key to loosen the M8x45 clamping screws (6). While doing this, hold the pneumatic motor (8) securely
in position.
2 Move the pneumatic motor (8) to the upper stroke position (Fig. A) (this can be done manually).
3 Move the pneumatic motor (8) upward in the motor bracket (9) until the front of the reamer (5) touches the front of the
gas nozzle (4) (Fig. B).
4 Tighten the M8x45 clamping screws (6) on the motor bracket (9) (minimum tightening torque 20 Nm).
BAL.0617.0 • 2021-11-23
Lower stroke position
6
A
6 M8x45 clamping screws
8 Pneumatic motor
6 Putting into operation
Upper stroke position
4
4
Reamer
limit stop
5
5
8
B
9 Motor bracket
EN - 27