Abicor Binzel TCS Compact Mode D'emploi page 62

6 Putting into operation
6.4 Setting up the pneumatic motor
9
1 Cleaning station
2 Welding torch
Fig. 21 Setting up the pneumatic motor
NOTICE
• Before you can set up the pneumatic motor in its final position, the welding torch has to be positioned in the cleaning
station.
 Fig. 20 Setting up the clamping position on page EN-25
• The motor stroke needs to be in the lower position (8) (stroke down).
 Fig. 21 Setting up the pneumatic motor on page EN-26
• If you need to replace the pneumatic motor, provide the pneumatic motor's (10) serial number when ordering.
EN - 26
1
8
3 Gas nozzle clamping 5 Reamer
device 6 M6x45 clamping screws
4 7
Gas nozzle AF6 Allen key
TCS Compact
2
3
4
5
6
7
10
8 Pneumatic motor (stroke
down)
9
Motor bracket
10 Pneumatic motor serial
number
BAL.0617.0 • 2021-11-23