Quick R02 Mode D'installation Et D'emploi page 17

Example of programming with translation:
Press key 3 on an RRC radio transmitter.
KEY PRESSED CORRESPONDENCE TO ENABLED RELAY
ON THE TRANSMITTER ON THE RECEIVER
1 (None)
2 (None)
3 1
4 2
Key 3 corresponds to relay 1, key 4 corresponds to relay 2.
Filter function (letter
This function allows to select three different interference noise filtering modes within the function submenu
(see table).
The receiver is supplied set in AVERAGE mode.
Filter function submenu table
LOW: select when using in environments with only slight interference
AVERAGE: factory setting. Select when using in normal conditions
HIGH: select when using in environments with great interference
Once selected, letter
on the current setting saved in the receiver) flash at a constant frequency.
Release the configuration button. By subsequently quickly pressing and releasing the configuration button letter
, or (flashing at a constant frequency) can be selected. Once the configuration has been chosen among
those selectable, keep the configuration button pressed until the letter starts to flash at a fast rate, confirming that
it has been saved; next, the letter
After 10 seconds, if the configuration button is not pressed, it will go back to the letter
Erasing the memory (letter
This function allows to erase from the receiver's memory all transmitter IDs that have been saved using the
programming function.
Once letter constantly on is selected, keep the configuration button pressed until letter
larly, passed 3 more seconds, it will start flashing at a faster rate. This confirms that it has been erased and then
the letter remains on. Release the programming button.
If the programming button is released before 5 seconds have passed, letter
and the erasing procedure is cancelled.
Exiting the configuration menu (
This function allows to exit from the configuration menu of the receiver.
Once the symbol is selected, keep the configuration button pressed, the
before shutting off. Release the configuration button. When exiting the configuration phase the ON/OFF LED will
start flashing again.
RADIO RECEIVER OPERATION
Reception of a command from the transmitter
When receiving a command from the RRC radio transmitter, the green ON/OFF LED will start flashing quickly.
The corresponding relay will activate and its activation is displayed by the red "relay activation" lighting up. Two
relays can be activated at the same time.
RRC R02/12 - REV003A
)
remains on; keep the configuration button pressed until letter
will appear and remain on. Release the programming button
)
simbol)
OPERATION
1
3
1 2
3 4
will go back to being on constantly
symbol will start flashing quickly
EN
1 2
2
3 4
5 6
4
7 8
9 10
11 12
, or (depending
being on constantly.
or
stored flashing regu-
17