Bonnet Neve DRIFT Instructions Pour L'utilisateur page 7

Modello - Modèle - Model
Modell - Modelo - Modelo
Fabbricante - Constructeur - Manufacturer
Hersteller - Fabricante - Fabricante
THE CABINET MUST NOT BE EXPOSED OR USED OUTSIDE THE STORE. IT MUST BE
PROTECTED FROM THE ELEMENTS. THE TOP SURFACE OF THE CABINET MUST STAY
FREE.
THE CABINET IS NOT AIMED FOR USE BY PERSONS WITH REDUCED PHYSICAL, SEN-
SORY OR MENTAL CAPACITIES, OR BY PERSONS NOT POSESSING THE REQUIRED EX-
PERIENCE OR KNOWLEDGE, UNLESS THEY ARE SUPERVISED BY A PERSON
RESPONSIBLE FOR THEIR SAFETY AND THEY HAVE THE RELEVANT EQUIPMENT IN-
STRUCTIONS AT HAND. SURVEILLANCE MUST BE EXERCISED ON CHILDREN IN ORDER
TO STOP THEM FROM PLAYING WITH THE EQUIPMENT.
THE POWER CORDS MUST BE PROPERLY SPREAD OUT, SAFE FROM SHOCKS AND FAR
FROM LIQUIDS, WATER AND HEAT SOURCES, AND THEY MUST NOT BE DAMAGED. THE
USE OF ADAPTOR PLUGS IS FORBIDDEN. IF THE POWER CORD IS DAMAGED, HAVE IT
REPLACED BY THE MANUFACTURER, BY THE AFTER-SALES SERVICE OR BY A PROFES-
SIONAL WITH SIMILAR QUALIFICATIONS.
ENSURE THAT THE POWER SUPPLY VOLTAGE MEETS THE DETAILS ON THE RATING
PLATE OF THE CABINET. THE CABINET MUST BE PROPERLY CONNECTED TO THE EAR-
THING SYSTEM OF THE BUILDING. BEFORE PERFORMING ANY JOBS ON THE CABINET,
DISCONNECT IT FROM THE POWER SYSTEM OR TURN THE MASTER SWITCH OFF.
THE EQUIPMENT AND THE CONDENSER MUST ONLY BE INSTALLED BY THE MANUFAC-
TURER'S AFTER-SALES PERSONNEL OR BY A PROFESSIONAL WITH EQUIVALENT QUA-
LIFICATIONS.
THE INFORMATION ATTACHED TO REMOTE-COOLED EQUIPMENT DOES NOT INCLUDE
INFORMATION ON THE TYPE OF REFRIGERATING UNIT THAT THEY ARE AIMED TO BE
CONNECTED TO.
DO NOT DAMAGE THE REFRIGERATING CIRCUIT: IT IS FORBIDDENT TO PIERCE OR
DRILL THE INTERNAL OR EXTERNAL WALLS OF THE CABINET IN ANY WAY (E.G. FOR
THE INSTALLATION OF A CABINET TOP), AS THIS COULD DAMAGE THE EVAPORATOR
PIPING.
DO NOT SPEED UP THE DEFROSTING PROCESS BY THE USE OF MECHANICAL DEVICES
OR OTHER MEANS NOT RECOMMENDED BY THE MANUFACTURER.
ONLY QUALIFIED PERSONNEL IS ALLOWED TO REMOVE PANELS OR GUARDS, AND
ESPECIALLY THE ELECTRIC BOARD COVER, WHEN THE USE OF TOOLS IS REQUIRED
FOR THIS PURPOSE.
ENSURE THAT THE AIR SLOTS AT THE BASE OF THE CABINET ARE FREE AND OPEN. DO
NOT USE DIRECT OR INDIRECT WATER JETS ON THE CABINET. DO NOT TOUCH THE
EQUIPMENT WITH DAMP OR WET HANDS OR FEET; DO NOT USE IT WHILE BAREFOOT.
NEVER EXCEED THE LOAD LIMIT OF 225 Kg/sq.m FOR BOTH SHELVES AND BASE DECK
PLATES
DRIFT
EPTA Spa - Via Mecenate 86 - 20138 Milano - ITALY
Tel. +39 02 5540 3211
UM000248
N° DOC:
7