Publicité
Les langues disponibles
Les langues disponibles
FROM IMPROPER, INCORRECT OR UNREASONABLE USE.
THE INSTRUCTIONS CONCERNING PERSONS (INCLUDING CHILDREN) WITH REDUCED PHYSICAL,
SENSORY OR MENTAL CAPABILITIES, OR LACK OF EXPERIENCE AND KNOWLEDGE AND CHILDREN
PLAYING WITH THE APPLIANCE ARE NOT REQUIRED
10. ORDINARY MAINTENANCE
AT TENT ION! BEFORE STARTING ANY MAINTENANCE OR CLEANING, DISCONNECT THE REFRIGE-
RATOR FROM THE ELECTRICAL POWER SUPPLY BY THE MAIN WALL CUT-OFF SWITCH ( fig . 1 7) .
IM PO RTAN T: During maintenance or cleaning operations, be sure that the light in the working area is suf-
ficient. If necessary use an additional source of light.
CLEANING THE DISPLAY CASE
1) Every week clean the outer surfaces of the display case with mild soap or detergent in lukewarm
water only. Wipe carefully with a soft cloth. Never clean it using inflammable or scouring agents, alcohol, acetone or
solvents. NEVER CLEAN THE DISPLAY CASE BY THE USE OF WATER JETS. Clean glass surfaces using glass-clea-
ning products only. The use of water is not recommended here, as it may cause scale to build up.
ATTENTION! NEVER WASH OR CLEAN THE UPPER SIDE OF THE DISPLAY CASE WITH WATER OR
LIQUIDS
2) Every month clean the cabinet's inside surfaces following the instructions provided in the preceding item
and those indicated herebelow:
3) Defrost the display case onea a year to let the ice that may formed between the fins melt. Frost may other-
wise prevent correct operation. Proceed as follows:
· Disconnect the display case from the electrical power supply by the wall main cut-off switch (fig. 17).
· Empty the appliance, store the contents in cold rooms or refrigerators that are adequate for keeping the requisite
preservation temperature.
· Wait until the cold room has reached ambient temperature.
· Clean the display case inside thoroughly with mild soap or detergent and lukewarm water. Wipe carefully with and
a soft cloth.
· After having carefully checked that the display case is completely dry inside, start the appliance again by the
wall cut-out switch. Allow a couple of hours before loading the products back again.
· Allow a couple of hours before loading the products back again.
4) The condenser is a self-cleaning wall model that does not require maintenance. However, for
maximum safety, it should be cleaned every two years, as follows:
Disconnect the unit from the power supply
Obtain an air compressor equipped with a gun.
Don a pair of protective gloves.
Use a ladder to access the roof of the unit and, in the event of island compositions, remove the cover bet-
ween the two cabinets. Be careful not to damage the roof of the unit during this operation. DO NOT WALK
on the roof of the unit.
Spray a jet of compressed air onto each condenser for a few seconds.
Following the reverse procedure, reassemble the unit.
Disassemble and assemble very slowly, using work gloves. It is advisable to have these clea-
ning operations carried out by authorized service personnel.
Any maintenance operation not included among the former steps must be carried out by the authorised
after-sales service or by qualified personnel.
31
Publicité
