Setting Hi Limit Setpoint; Einstellung Des Sollpunkts Für Obergrenze • Réglage Du Point De Consigne; Limite Haute • Establecimiento Del Punto De Ajuste Del Límite Alto - 3D Systems PROJET 350 Série Guide De L'utilisateur

Setting HI LIMIT Setpoint

Einstellung des Sollpunkts für OBERGREN ZE • Réglage du point de consigne
LIMITE HAUTE • Establecimiento del punto de ajuste del LÍMITE ALTO • Impostazione
del punto di regolazione LIMITE SUP
Never enter a setpoint above the maximum operating temperature of 204 °C (400 °F)
The HI LIMIT setpoint for VisiJet part finishing is between 80 °C and 89 °C
(176 °F and 192 °F) . T o view or change this setpoint on the
1 If LOCK LED is on, press and hold
2 Press . The HI LIMIT setpoint
3 Press or to change the setpoint.
4 Press or RESET to save the new setpoint. The display changes back to the chamber
temperature with the PV LED on and the
If the chamber temperature exceeds the HI LIMIT setpoint, the heater shuts off. T o reset
the heater, see Resetting Heater on page 47
HI LIMIT
RESET for 4 seconds to enable
HSP1 LED is on when the setpoint is displayed.
HSP1 LED off.
.
.
HSP1
control panel:
HSP1 -Sollpunkt-LED
DEL du point
and .
de consign HSP1
Diodo electroluminiscente
del punto de ajuste HSP1
LED del punto di
regolazione HSP1
HSP1 -börvärdeslysdiod
HSP1 setpunkt-LED
HSP1 -asetusarvon
loistediodi
setpoint LED
41
T
HI LIMIT