Table des Matières
Publicité
Safety
Sicherheit • Sécurité • Seguridad • Sicure zza • Säkerhet • Sikkerhed • Turvallisuus
WARNING • Read this guide and observe all safety precautions before using this equipment. Failure to observe these precautions can res ult in
equipment damage and severe injury. Setup, maintenance, and operat
WARNING • All grounding and safety equipment must be in compliance with applicable codes, ordinances, and accepted safe practices.
WARNING • Do not use the InVision
in this Finisher. Do not process closed containers of any substance or liquid in this Finisher because they may explode when he ated.
Never operate Finisher in excess of the maximum operating temperature of 204 °C (400 °F) .
Never open the chamber door when the Finisher chamber temperature is above 100 °C (212 °F) . Wait until it cools to the TEMP CONTROL
setpoint or below as shown on the TEMP CONTROL PV display. (See p. 3.) Do not tip the tray of hot dip-finishing liquid. Scoop out the liquid
before moving the tray, or wait for the liquid to cool and solidify.
WARNING * Disconnect power from the finisher before attempting service or performing any maintenance.
™
Finisher in wet, corrosive, or explosive atmospheres. Do not use flammable solvent or flammable material
ion of this equipment must only be performed by qualified per sonnel.
i
T
Publicité
Table des Matières
