Troubleshooting Guide - EINHELL GC-SC 36/31 Li Traduction Du Mode D'emploi D'origine

10. Troubleshooting guide

Problem
Motor does not
start
Motor performance
drops
Imprecise
scarifying result
Motor is running,
cutting unit is not
rotating
Important! For protection, the motor is equipped with a thermal switch which cuts out when
the motor is overloaded and switches on again automatically after a short cooling period.
If the equipment will not work in spite of the troubleshooting measures and the voltage supply being OK,
please contact customer service (see section 7.5).
Anl_GC_SC_36_31_Li_USA_SPK7.indb 19 Anl_GC_SC_36_31_Li_USA_SPK7.indb 19
EN
Possible cause
a) Internal terminals disconnected
b) Safety lock-off defective
c) The scarifi er housing is clogged
d) Safety plug is not inserted
e) Battery is not correctly inserted
a) Soil too hard
b) The scarifi er housing is clogged
c) Blade badly worn
a) Blade worn
b) Wrong scarifi er height
a) Toothed belt is torn
- 19 -
Remedy
a) By customer service workshop
b) By customer service workshop
c) Change the scarifi er depth if
necessary; clean the housing so
that the cutting unit can rotate
freely
d) Insert the safety plug (see 6.)
e) Remove the battery and reinsert
(see 5.)
a) Correct the scarifi er depth
b) Clean the housing
c) Replace the blade
a) Replace the blade
b) Correct the scarifi er depth
a) By customer service workshop
28.01.2020 16:44:12 28.01.2020 16:44:12