Off & Go Function; Direct Power On/Off Function; Effective Tools For Your Presentation - Sony VPL-CX85 Mode D'emploi

Key Function
LASER Emits a laser beam.
G SLIDE g
Changes the slides in
the forward/backward
direction.
B Displays/cancels a
black screen during the
slide show.
* Also available when not using the Air Shot.
Note
If there is any obstruction between the
presentation tool and the remote control
detector on the projector, the presentation tool
may not function properly.
Off & Go Function
If you are leaving the conference room
immediately, turn the projector off, and then,
after the lens protector closes and the
powered tilt adjuster is put away in the
projector, you can unplug the AC power
cord. After the AC power cord is unplugged,
the fan runs automatically.
Notes
• When unplugging the AC power cord, ensure
that the lens protector closes and the powered
tilt adjuster is put away in the projector.
Moving the projector with the powered tilt
adjuster rised may damage the adjuster.
• Turn off the projector according to the
procedure in "Turning off the power", then
cool it down when storing the projector in the
carrying case.

Direct Power On/Off Function

If you will be using a circuit breaker to turn
the power for the entire system on and off,
set the direct power on function to "On."
When you turn off the power, you can also
just unplug the power cord without pressing
the I / 1 key. The internal circuitry will
cause the fan to automatically operate for a
certain time even after the power cord is
removed.
*
Note
However, if the unit has been on for less than
15 minutes, the fan might not begin to turn as a
result of inadequate charging. In that case,
follow the procedure for turning off the power
as described in "Turning Off the Power" on
page 25.
Effective Tools for Your
Presentation
To enlarge the image (Digital Zoom
function)
You can select a point in the image to
enlarge. This function works when a signal
from a computer is input, or when a still
picture (except a movie picture) stored in a
Memory Stick is projected.
This function does not work when a video
signal is input.
1
Project a normal image, and press the
D ZOOM + key on the Remote
Commander.
The digital zoom icon appears in the
center of the image.
2
Move the icon to the point on the
image you want to enlarge. Use the
arrow key (M/m/</,) to move the
icon.
3
Press the D ZOOM + key again.
The image where the icon is located is
enlarged. The enlargement ratio is
displayed on the screen for a few
seconds.
By pressing the + key repeatedly, the
image size increases (ratio of
enlargement: max. 4 times.)
Digital zoom
icon
29
Other Functions
GB