Other Functions; Switching From The Intelligent Auto-Setup Function To Manual Adjustments; Controlling The Computer Using The Supplied Remote Commander (When Using The Usb Cable); Controlling The Computer Using The Supplied Presentation Tool (When Using The Air Shot) - Sony VPL-CX85 Mode D'emploi

4
Turn the main power off and
disconnect the AC power cord.
The security lock is set to on, then it
becomes effective. The screen for
entering the password is displayed when
the power is turned on the next time.
Security certification
When the screen for entering the password is
displayed, enter the password that was set. If
you fail to enter the correct password after
three tries, the projector cannot be used. In
this case, press the I / 1 key to turn off the
power.
To cancel the security lock
1
Press the MENU key, then turn off the
"Security Lock" setting in the
INSTALL SETTING menu.
2
Enter the password.
Enter the password that was set.
Note
If you call the customer service center
because you have forgotten the password,
you will need to be able to verify the
projector's serial number and your identity.
(This process may differ in other countries.)
Once your identity has been confirmed, we
will provide you with the password.

Other Functions

Switching from the Intelligent
Auto-setup Function to
Manual Adjustments
You can switch the following functions of
the Intelligent Auto-setup to manual
adjustments using the menu.
V Keystone correction (correction
•
of trapezoidal distortion)
Set "V Keystone" in the INSTALL
SETTING menu to "Manual."
28
GB
Other Functions
• Smart APA (Auto Pixel Alignment)
Set "Smart APA" in the SET SETTING
menu to "Off."
• Auto Input Search
Set "Auto Input Search" in the SET
SETTING menu to "Off."
For details on the menu operations, see
"Using the MENU" on page 31.
Controlling the Computer
Using the Supplied Remote
Commander (When Using the
USB Cable)
When you connect a computer to the
projector by using the USB cable, you can
control the mouse of the computer using the
Remote Commander.
The R/L CLICK keys and joystick function
as follows.
Key and joystick Function
R CLICK (front) Right button
L CLICK (rear) Left button
Joystick Corresponds with the
movements of the
mouse
For details on USB connection, see "To
connect a computer" on page 20.
Note
Make sure that nothing obstructs the infrared
beam between the Remote Commander and the
remote control detector on the projector.
Controlling the Computer
Using the Supplied
Presentation Tool (When
Using the Air Shot)
When you are using the Air Shot to project
the picture from a computer, you can
perform some operations for a slide show
using the supplied presentation tool. The
following keys on the presentation tool are
usable.