Assembly And Operation; Applications; Prior To Operation - Hitachi WR 22SE Mode D'emploi

English

ASSEMBLY AND OPERATION

APPLICATIONS

○ Tightening and loosening various kinds of bolts and nuts.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms to the power source requirements
specifi ed on the product nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the plug is connected to a receptacle while
the switch is in the ON position, the power tool will start operating immediately and can cause
serious injury.
3. Extension cord
When the work area is far away from the power source, use an extension cord of suffi cient
thickness and rated capacity. The extension cord should be kept as short as practicable.
4. Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired. Contact a
licensed electrician to make appropriate repairs.
If such a faulty receptacle is used, it may cause overheating, resulting in a serious hazard.
5. Confi rming condition of the environment
Confi rm that the work site is placed under appropriate conditions conforming to prescribed
precautions.
6. Mounting the side handle
After loosening the handle, slide it
over the main unit and tighten the
handle to secure it. When sliding
over the main unit, make sure to
align the unit's protrusion with the
side handle's slot. (Fig. 2)
8
WARNING:
Damaged cord must be replaced or repaired.
Handle
protrusion
slot
Fig. 2