Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY AND OPERATION
APPLICATIONS
Use as a Hammer drill
Drilling of soft bricks and concrete blocks.
Use as a drill
Drilling of soft steel, wood, plastic and aluminum materials.
Use as a screwdriver
Tightening and loosening of machine screws, wood screws and tapping screws.
REMOVAL AND INSTALLATION METHOD OF BATTERY
Insert
Pull
out
Fig. 3
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if damaged. Have it repaired immediately.
All manuals and user guides at all-guides.com
How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Handle
Always insert it all the way until it locks in place with
a little click, If not, it may accidentally fall out of the
Latch
tool, causing injury to you or someone around you.
Push
(Fig. 3)
How to remove the battery.
Battery
Withdraw battery from the tool handle while pressing
the latches on the sides of the battery. (Fig. 3)
English
11
Publicité
Table des Matières
