eufy Security EUFYCAM 2 Guide De Démarrage Rapide page 8

NOTICE
FCC Statement
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept
any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
Note: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures: (1)
Reorient or relocate the receiving antenna. (2)
Increase the separation between the equipment
and receiver. (3) Connect the equipment into
an outlet on a circuit different from that to
which the receiver is connected. (4) Consult the
dealer or an experienced radio/TV technician
12 EN
for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general
RF exposure requirements. The device can be
used in fixed/mobile exposure condition. The
min separation distance is 20cm.
Notice: Shielded cables
All connections to other computing devices
must be made using shielded cables to maintain
compliance with FCC regulations.
The following importer is the responsible party
Company Name: Fantasia Trading LLC
Address: 9155 Archibald Avenue, Suite 202,
Rancho Cucamonga, CA 91730, USA
Telephone:1-909-484-1530
This product complies with the radio
interference requirements of the
European Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that
this device is in compliance with the essential
requirements and other relevant provisions of
Directive 2014/53/EU. For the declaration of
conformity, visit the Web site www.eufylife.com
Due to the used enclosure material, the product
shall only be connected to a USB Interface of
version 2.0 or higher.
The adapter shall be installed near the
equipment and shall be easily accessible.
Do not use the Device in the environment at
too high or too low temperature, never expose
the Device under strong sunshine or too wet
environment.
The suitable temperature for HomeBase 2 and
accessories is -10°C-45°C.
The suitable temperature for eufyCam 2 and
accessories is -20°C-50°C.
When charging, please place the device in
an environment that has a normal room
temperature and good ventilation.
It is recommended to charge the device in an
environment with a temperature that ranges
from 5°C~25°C.
Please ensure to use only the charger offered by
the manufacturer. Using unauthorized charger
may cause danger and violate the authorization
of the device and the guarantee article.
This charger is for indoor use only
The charger type is ASSA67W-120200,
output voltage/current is 12Vdc/2A. The plug
considered as disconnect device of adapter.
RF exposure information: The Maximum
Permissible Exposure (MPE) level has been
calculated based on a distance of d=20 cm
between the device and the human body.
To maintain compliance with RF exposure
requirement, use product that maintain a 20cm
distance between the device and human body.
CAUTION RISK OF EXPLOSION IF BATTERY
IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS.
Wi-Fi Operating Frequency
Range: 2412~2472MHz ; Wi-Fi Max
Output Power: 17.47 dBm
SUB-1G Frequency range: 866~866.8MHz;
SUB-1G Output Power: 5.492 dBm
The following importer is the responsible party
(contact for EU matters only)
Importer: Anker Technology (UK) Ltd
Importer Address: Suite B, Fairgate House, 205
Kings Road, Tyseley, Birmingham, B11 2AA,
United Kingdom
This product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
This symbol means the product must not be
discarded as household waste, and should
be delivered to an appropriate collection
facility for recycling. Proper disposal and
recycling helps protect natural resources,
human health and the environment.
For more information on disposal and
recycling of this product, contact your local
municipality, disposal service, or the shop
where you bought this product.
IC Statement
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause undesired
operation of the device."
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement."
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
IC RF Statement:
When using the product, maintain a distance of
20cm from the body to ensure compliance with
RF exposure requirements.
Lors de l'utilisation du produit, maintenez
une distance de 20 cm du corps afin de
vous conformer aux exigences en matière
d'exposition RF.
EN 13