Kratki LUCY 12 Mode D'emploi Et Garantie page 15

b) The fireplace insert needs to be installed and commissioned by a company with appropriate
qualifications and experience.
c) The fireplace insert should be located as close to the chimney flue as possible. central to the proper
operation of the insert is the required amount of air and an efficient ventilation system in the room
where it is going to be installed.
d) When carried, the fireplace insert cannot be held by the elements of the damper, since this might
damage its mechanism.
e) before starting to use the insert, labels must be removed from the pane.
f ) The technical parameters of the insert apply to the fuel as defined in these instructions.
g) deadlines for the inspection of the chimney flues must be definitely met (at least twice a year).
h) The current law prescribes that a fireplace may not be the sole source of heat, but only a comple-
ment to the existing heating system. This is because a building must heated even if occupants are
not at home for a long time.
The fireplace insert should be installed in compliance with the provisions of relevant standards,
requirements of the construction law and fire standards. detailed regulations concerning the safety
of a structure, fire safety and safe use are contained in the act on construction law of 7 July 1994
(Journal of laws, no. 156, item 1118 of 2006 with subsequent changes), the directive of the Minister
of infrastructure of 12 april 2002 on the technical conditions that should be met by buildings and the
locations thereof (Journal of laws, no 75, item 690 of 2002 and Journal of laws no. 109, item 1156 of
2004), the pn-en 13229:2002 "fireplaces and fireplace inserts for solid fuels. requirements and test
methods", and the standard pn-en13240:2002 „ room heaters fired by solid fuel. requirements and
Test Methods".
2. Purpose
The fireplace inserts by the kratki.pl company are classified as continuously burning furnaces with
a manual fuel input and a closed firebox door. They are designed to be enclosed or built in a niche
and to burn broad-leaved wood (brow coal briquette is also permissible). as an additional source of
heat, they can be used in the rooms where they are installed. The enclosure of the insert should be
constructed in such a way as to make it possible to install and remove the fireplace without dama-
ging this enclosure. in addition to that, it is also supposed to provide constant access to the waste gas
throttle or the chimney draught damper, as well air access for combustion and ventilation purposes
through vent grilles (on both sides of the fireplace, in the lower part of the enclosure) and a larger
outlet grille in the upper part of the enclosure.
3. Description of the device
all ceramic and cast iron components of the fireplace inserts are available from the manufacturer.
Attention: some fireplace inserts are as standard equipped with a baffle made of vermiculite or
concrete.
Attention: if present, the ribbing of the grate should be positioned upwards.
4. Installation of the fireplace insert
The fireplace insert should be installed by a person qualified for carrying out such installations. it is
only after this condition has been met that the fireplace insert can be safely used. When the instal-
lation is completed, the installer is expected to confirm its correctness by signing and stamping the
guarantee certificate. in case of the failure to meet this requirement, the buyer forfeits the right to lay
claims to any guarantee compensation from the manufacturer of the fireplace insert.
4.1. preparing for installation. The fireplace insert is delivered as being ready to be enclosed and instal-
led. after unpacking the device, it needs to be checked for completeness according to the instructions.
additionally, it is necessary to check the following for correct operation:
• mechanism to control the chimney draught (rotary damper in the stack of the insert);
• mechanism to control air supplied to the combustion chamber (ash pan drawer);
• closing mechanism of the front door (hinges, handle);
15