Kratki LUCY 12 Mode D'emploi Et Garantie page 13

EN
WARNING! To prevent fire, the device must be installed in compliance with technical standards
and regulations, as referred to in the instructions.
Only a professional or a skilled person can install the device. The device complies with the EN
13240 standard and has the CE certificate.
It is imperative that the regulations in force where the device is installed be always observed.
First of all, it is necessary to make sure that the chimney flue is appropriate.
General information
The device must be installed in compliance with the regulations of the construction law in force, at
a safe distance from any flammable product. it may be necessary to secure the walls and the materi-
als that surround the fireplace. The device needs to be located on a solid, non-flammable base. it
must be ensured that the chimney is tight and has smooth walls, with carbon black and dirt removed
before connecting. The connection between the chimney and the device needs to be tight and made
of non-flammable materials, as well as protected against oxidation (enamelled or steel chimney pipe).
if the chimney generates a poor draught, it might be advisable to install a new flue. on the other
hand, the draught generated by the chimney should not be too strong; if so, a draught stabilizer
needs to be installed in the chimney. special chimney ends provide an alternative solution, control-
ling the draught as they do. The task of inspecting the chimney should be entrusted to a chimney
sweep, and any modification may be made only by an authorized company, so that the requirements
of the pn-89/b-10425 standards are fulfilled.
Example of connection with the chimney
cleanout
diameter of the joint with the chimney flue
Lighting a fire for the first time WARNING!
When the fire is lighted for the first few times, the device should operate with a decreased air-
supply in order to enable its parts to dilate normally. Handles and grips are hot while the fireplace
operates. Acrid smoke and pungent smell coming out of the room heater when the fire is lighted for
one of the first few times should not cause any anxiety, since this is due to the combustion of paint
(polymerization of paint) on various parts of the device.
chimney flue
non-flammable
material
Mortar
rosette
cold combustion air inlet
13