Set-Up; Operation - Fellowes PS60-2 Mode D'emploi

Set-Up

For safety reasons, this model will operate only if the shredder head is in the correct posi-
tion on the basket. Align slot (A) at the back of the shredder head with tab (B) on the
back of the basket and place it onto the basket in this position.

Operation

For convenience, your shredder is equipped with an automatic-start sensor (C). This
means that when the control switch (D) is on automatic [I] position, the shredder will start
running when you put paper into it and stop a few seconds after the paper has passed
through. Because the sensor cannot tell the difference between paper and other objects,
this feature can also be a hazard, especially to children and pets. To avoid accidents, turn
off the shredder as soon as you are finished. Unplug shredder if it will not be used for an
extended period.
To shred
• Plug in shredder with control switch (D) in off [O] position
• Press control switch to automatic [I] position; cutting cylinders will run for 1-2 seconds to
signal readiness and green light (H) will turn on.
• Feed paper straight into entry (E), until the shredder automatically begins shredding; see
Product Profile for limits on paper width, shreddable items, sheet capacity, etc.
• Shred for no more than 10-12 minutes; shredding longer will cause shredder to turn itself
off for 20 minutes to cool down.
• Press control switch to off [O] position after cutting has stopped. With confetti-cut shredder,
cutting continues for several seconds after paper has gone through in order to clear shred-
ded paper from cutting cylinders.
In case of a paper jam, which may occur if the shredder is pushed beyond its specified
capabilities, press the control switch to the off [O] position and empty the basket if full.
Then:
1) Press and hold control switch in reverse [R] position and attempt to back paper out of
shredder.
2) If shredder jams in reverse mode, press control switch to automatic [I] position and
attempt to continue shredding operation.
3) If shredder jams again, alternate control switch slowly between reverse [R] and automat-
ic [I] positions to attempt to move jammed paper completely through shredder.
If you are unable to clear the jam using this method, turn off and unplug the shredder;
remove shredder head from the wastebasket and carefully remove any paper extending
below the cutting cylinders; empty the wastebasket; reassemble the shredder and repeat
jam clearing procedure.
4