Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

A
.
B.
C.
D.
E.
F.
CAPABILITIES
Will shred: Paper only
Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper, junk
mail, credit cards, CD/DVDs, staples, paper clips, cardboard, laminates, file folders, X-rays
or plastic other than noted above
Paper shred size:
High Security ..................................... (Din 6) 1/32 in. x 3/16 in. (0.8mm x 5.0mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
manual. Read the entire instruction manual before operating shredders.
to off or unplug when not in use.
openings. If object enters top opening, switch to Reverse (R) to back out object.
products on or near shredder. Do not use canned air on shredder.
Do not place near or over heat source or water.

BASIC SET UP

SHREDDER SET-UP
1
2
Open the door
Place cutter head into
top of cabinet, use 2
people
2
G.
H.
3
4
Ensure access to a
Make sure safety flap
dedicated 15Amp,
is securely in place
120V outlet
KEY
A. Safety Shield
B. Paper entry
C. Disconnect switch (open door)
D. Door
E. Basket
F. Casters
G. See safety instructions
Maximum:
Sheets per pass .....................................................................................................4*
Paper entry width .......................................................................9-1/2 in. (240 mm)
* 8.5 in. x 11 in., 20lb., (75g) paper at 120V, 60 Hz, 3.2Amps; heavier paper, humidity or
other than rated voltage may reduce capacity.
*In order to perform at capacity, shredder must be plugged into a dedicated 15Amp, 120V
outlet and oiled every 15-30 minutes of continuous use.
be fully closed to operate shredder. In case of emergency, open cabinet door. This
action will stop shredding immediately.
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
BASIC SHREDDING OPERATION
TO SHRED
1
2
Press ( ) ON to
Plug in and make
activate
sure door is closed
H. Control Panel and LEDs
1. ON/OFF (blue)
R 2. Reverse (red)
3. Bin full (yellow)
4. Door open (red)
5. Safety Shield Open (red)
3
4
or
Feed paper straight
When finished
into paper entry and
shredding set to
release
( ) OFF
ENGLISH
Model HS-440
5
Do nothing and shredder
will automatically shut-
off after 30 minutes of
inactivity

Publicité

Table des Matières
loading

Table des Matières