Cavist 224 Manuel D'utilisation page 4

INSTALLATION INSTRUCTIONS
Before Using Your Wine Cooler
Remove the exterior and interior packing.
Before connecting the wine cooler to the power source, let it stand upright for approximately 2 4
hours. This will reduce the possibility of a malfunction in the cooling system from improper handling
during transportation. Clean the interior surface with lukewarm water using a soft cloth. (Cleaning
instruction below)
Installing Your Wine Cooler
This wine cooler is designed to be free standing only, and should not be installed in a recessed wall.
Allow 5 inches of space between the back and sides of the wine cooler for proper air ventilation.
Adjust the feet to keep the wine cooler level. Place the wine cooler away from direct sunlight and
sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Ambient temperature below 5°C or above 32°C will
hinder the performance of this appliance.
This unit is not designed for use in a garage or any other outdoor installation.
Avoid placing or situating the wine cooler in moist areas.
Plug the wine cooler into a dedicated, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and/or grounding should be directed toward a certified electrician or an authorized service
center.
This unit is not designed to be installed in an RV or used with an inverter.
After plugging the wine cooler into a wall outlet, turn the unit on and allow the unit to cool down for
3 ~ 4 hours under before placing wine bottles or beverages in the appliance.
Electrical Connection
a ~WARNING~ a
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized service center.
This wine cooler should be properly grounded for your safety. The power cord of this wine cooler
is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize
the possibility of electrical shock.
Do not, under any circumstances, cut or remove the third ground prong from the power cord supplied.
This wine cooler requires a standard 220~240 Volt A.C. /50Hz electrical outlet with three-prong
ground.
This wine cooler is not designed to be used with an inverter.
The cord should be secured behind the wine cooler and not left exposed or dangling to prevent
accidental injury.
Never unplug the wine cooler by pulling the power cord. Always grip the plug firmly and pull straight
out from the receptacle.