Télécharger Imprimer la page

Beta 1498LT/12 Mode D'emploi page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
INSTRUCTIONS FOR USE
ISTRUZIONI PER L'USO
• Never connect the starter to a vehicle with active manual functions. Such functions should only be
enabled after the clamps have been connected to the battery of the vehicle – that is, when polarity is
checked and any short-circuits detected.
• To clean the starter, use a dry cloth. Always disconnect the starter from the power supply mains.
Never use damp or wet cloths.
PORTABLE STARTER SAFETY
• Periodically check the starter, the power supply cable and the clamps.
• Do not use the starter when damaged; do not try to open or modify it.
• Connect the charger of the starter to the mains socket, making sure that the mains voltage matches
that stated on the power supply device. (See TECHNICAL DATA table).
• Allow adequate space for ventilation when using the starter.
• When charge is complete, do not leave the starter connected to the battery charger for a long period.
• Do not use the starter in humid or wet environments; do not expose it to rain. Wet and contaminated
environments increase the risk of electric shocks.
• To charge the starter, only use the charger supplied with it.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING PORTABLE STARTER
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR SAFETY SHOES
ALWAYS WEAR EYE PROTECTION
ALWAYS WEAR PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE OPERATING STARTER
Additional personal protective equipment to wear according to the values found in the
environmental hygiene/risk analysis survey if the values exceed the limits under current
regulations.
TECHNICAL DATA
FOR USE WITH BATTERIES
STARTER CHARGER – VOLTAGE RATING
INTERNAL BATTERY (Lithium LiFePO4)
ADDITIONAL BATTERY
CHARGING VOLTAGE
CLIP CABLE LENGTH
CLIP CABLE SECTION
POLARITY REVERSAL PROTECTION
SHORT CIRCUIT PROTECTION
OVERVOLTAGE PROTECTION
MEMORY SAVER
IDEAL OPERATING TEMPERATURE
DIMENSIONS
WEIGHT
12V
230V ~ 50/60Hz
13.2V (rated)
9V (6LR61)
14.5V max
0.5 m
CU 10mm2
YES
YES
YES
YES
-10 °C ± +40 °C
300x230x60 mm
2.5 kg
EN
I
11

Publicité

loading