Electrolux ECG6200 Mode D'emploi page 106

822_949_387 ECG6200_Elux.book Seite 106 Sonntag, 27. Januar 2008 11:07 23
g
preparation of next coffee (see „Set-
ting the grinding texture", page 100).
• Wrong type of coffee.
0 Use a type of coffee for fully auto-
mated espresso makers.
The coffee runs out too slowly
• The coffee is ground too finely.
0 Turn the knob for setting grinding tex-
ture one click clockwise whilst the
grinder is grinding beans for the prep-
aration of next coffee (see „Setting the
grinding texture", page 100).
The coffee runs out too quickly
• The coffee is ground too coarsely.
0 Turn the knob for setting grinding tex-
ture one click anticlockwise whilst the
grinder is grinding beans for the prep-
aration of next coffee (see „Setting the
grinding texture", page 100).
The coffee flows out of only one of
the dispensers
• The dispenser holes are blocked.
0 Scrape off the dry coffee residues with
a needle (Fig. 29).
When the knob for steam and hot
water is turned, no steam comes out
of the steam nozzle
• The holes in the steam nozzle and the
inner part of the steam nozzle are
clogged.
0 Clean the holes in the steam nozzle
and the inner part of the steam nozzle
(see „Cleaning the steam nozzle",
page 99).
When the
selected, the appliance does not
deliver coffee, but only water
• The ground coffee may be blocked in
the ground coffee filler.
0 Remove the ground coffee inside the
filler using a knife (see „Using pre-
ground coffee", page 98) (Fig. 22). Then
clean the brewing unit and the inside
of the appliance (see „Cleaning the
brewing unit", page 102)
106
or function is
When the button
appliance does not switch on
• The main switch at the back is not
switched on (fig. 8) or the appliance is
not plugged in.
0 Check that the main switch is in the "I"
position and that the power cable is
plugged into the mains socket.
The brewing unit cannot be removed
for cleaning
• The appliance is on. The brewing unit
can only be removed if the appliance is
off.
0 Turn the appliance off and remove the
brewing unit (see „Cleaning the brew-
ing unit", page 102).
3 Important: The brewing unit can only
be removed if the appliance is turned
off with the ON/OFF key
front. It should not be disconnected
from the mains. Attempting to
remove the brewing unit when the
appliance is on may cause serious
damage.
The coffee does not run out from
the dispenser outlets, but from
around the sides of the service door
• The holes in the dispenser outlets are
clogged with dry coffee.
0 Remove the dried coffee with a needle
(Fig. 29).
• The tilt compartment (R) inside the ser-
vice door is blocked and cannot swing.
0 Thoroughly clean the tilt compartment,
particularly near the hinges, to ensure
they are free to swing smoothly.
Ground coffee was used (not beans)
and the appliance does not deliver
any coffee
• Too much ground coffee has been
added.
0 Remove the brewing unit and thor-
oughly clean the inside of the appli-
ance, as described in „Cleaning the
brewing unit", page 102. Repeat the
operation using a maximum of 2
scoops of ground coffee.
is pressed, the
at the