Electrolux ECG6200 Mode D'emploi page 96

822_949_387 ECG6200_Elux.book Seite 96 Sonntag, 27. Januar 2008 11:07 23
g
Depending on your taste, select a
"short" espresso or a "long" milky coffee.
0 To choose the required cup size, turn
the knob for "Cup size" (Fig. 12). The
selected cup size will be indicated.
3 The cup sizes are indicated as follows:
You can also choose coffee with an
extra-mild, mild, normal, strong or
extra-strong strength.
0 To choose the required strength, turn
the knob for "Coffee strength selec-
tion" (Fig 13). The selected coffee
strength will be indicated.
3 The coffee strength is indicated as fol-
lows:
extra-mild
mild
normal
strong
extra-strong
0 Place one or two cups under the coffee
dispensing spouts (Fig. 14). The dis-
penser can be slid up or down, to
match the height of your cup/mug to
reduce heat loss and coffee splashes
(Fig. 15).
0 Press the key for "1 cup"
one cup, or the key for "2 cups"
make 2 cups.
The symbol "1 cup"
comes on. The appliance now grinds
the beans. In the coffee-making proc-
ess, the ground coffee is first of all
wetted with a small quantity of water
for pre-brewing. Following a short
pause, the actual brewing process
commences. The coffee is dispensed
into the cup.
When the desired quantity of coffee
has been dispensed, the appliance
automatically stops delivering the cof-
fee and ejects the grounds into the
96
0 You can stop the delivery of coffee
espresso cup
small cup
0 As soon as delivery is complete, to
medium cup
large cup
mug
3
3
to make
to
or "2 cups"
3
3
waste coffee container. During this
time, the symbol "1 cup"
cups" flashes.
prematurely at any time, by briefly
pressing the key for "1 cup"
cups" , or by turning the knob for
"Cup size" (Fig. 12) anti-clockwise
towards the "Espresso cup" position.
increase the quantity of coffee, simply
press and hold the key for "1 cup"
or "2 cups" until the desired quan-
tity is reached, or turn the knob for
"Cup size" (Fig. 12) clockwise towards
the "Mug" position (this operation
must be performed immediately after
the coffee is dispensed and before the
coffee grounds are ejected into the
waste coffee container).
After a few seconds, when the flashing
symbol "1 cup" or "2 cups"
goes off, the appliance is ready for use
again and you can make another cof-
fee.
If the coffee is delivered a drop at a
time or not at all, or the coffee is deliv-
ered too fast and is not creamy
enough, you should change the grind-
ing setting; see „Setting the grinding
texture", page 100.
If the symbols and are flashing,
the coffee is ground too fine. You
should change the grinding setting; see
„Setting the grinding texture",
page 100.
If the symbol comes on the water
tank must be refilled or the appliance
will not make coffee. (It is normal for
there still to be some water left in the
tank when the symbol is displayed).
If the symbol comes on the waste
coffee container is full and must be
emptied and cleaned; see „Emptying the
waste coffee container", page 102. Until
the waste coffee container has been
cleaned, the appliance continues to dis-
play the symbol and cannot make coffee.
or "2
or "2