Publicité
Les langues disponibles
Les langues disponibles
Safety / Start-up
Ensure before use that the available mains
voltage is the same as the voltage required for
operating the lamp (230–240 V∼).
Strictly ensure that the light does not come into
contact with water or other liquids.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Do not install the light on a damp or conducting
surface.
Do not use the light with sockets which have a
hinged cover.
Prevent fire and
injury hazards
RISK OF INJURY! Check the light regularly
and before every use to see if there is any
damage to the casing and mains plug.
Never use the light if any defects have been
identified.
RISK OF BURNS! To prevent burns, ensure
that the light is switched off and has cooled
down before touching it. Lamps develop a lot
of heat in the area of the lamp head.
Allow the light to cool completely.
Do not look directly into the light source (lamp,
LED, etc.).
The lamp is not replaceable.
If the light bulb is defective, the entire light must
be disposed of.
This light is not suitable for dimmer or electronic
switches.
In order to disconnect the light completely from
the power supply, the light must be removed
from the socket.
Do not leave the light or packaging material
lying unattended. Plastic film or bags and
Styrofoam etc. can turn into dangerous toys for
children.
Safe working
Install the light so that it is protected from mois-
ture, dirt and excessive heat temperature.
6
GB/IE
Constant attentiveness is required! Always pay
attention to what you are doing and act with
common sense. Never use the light if you are
having difficulty concentrating or do not feel
well.
Familiarise yourself before use with all instructions
and diagrams in this manual as well as with
the light itself.
This product is only to be used as a wall light
or reading light. Do not use this light as a night
light.
Start-up
Installing / uninstalling the light
Connect the plug of the light to the mains socket.
Check that it is correctly plugged in. Your light
is now ready to use.
Directing the spotlight
Only change the direction of the spotlight
with the light unplugged.
Allow the light to cool completely.
Turn the spotlight
1
direction.
Switching on and off
Switching the light on:
Set the switch
to the „AUTO" position.
2
– Motion detector is active.
– The automatic darkness sensor is switched on.
– The light switches on automatically for ap-
prox. 60 seconds, if there is motion within
the detection range.
– The function only operates if there is darkness.
Set the switch
to the „ON" position.
2
– The light is switched on permanently.
– The motion detector is switched off.
– The automatic darkness sensor is switched off.
1
carefully in the desired
Publicité
